Tweet
I was looking for a pistol grip for my 1.4 but the ones I saw on Amazon all have a mounting screw that is too short (the female thread is the bottom of the camera case is a bit recessed) so I made my own.
I started with a small maple branch that felt good in my hand & cut it to size. The mounting screw is made of an old plastic knob with a piece of 1/4" bolt epoxied into it. Sanded then finished with tung oil.
High tech meets low tech.
Its a bit front heavy so I'll keep my eye open for a more suitably shaped branch when I'm cutting firewood this summer.
I started with a small maple branch that felt good in my hand & cut it to size. The mounting screw is made of an old plastic knob with a piece of 1/4" bolt epoxied into it. Sanded then finished with tung oil.
High tech meets low tech.
Its a bit front heavy so I'll keep my eye open for a more suitably shaped branch when I'm cutting firewood this summer.